Rockwell Hardness
Can any one help how to calibrate a rockwell hardness machine?
Rockwell Test Blocks and Calibration Sets
Standard Rockwell test blocks provide an easy means of checking your...
Rockwell Hardness

Can any one help how to calibrate a rockwell hardness machine?
Rockwell Test Blocks and Calibration Sets
Standard Rockwell test blocks provide an easy means of checking your tester's accuracy at any time, and periodic use on a regular basis is recommended for all models. Comparing a test reading of the block with the hardness number on the test block will indicate whether or not the instrument needs attention. Providing the standards of the industry, Rockwell test blocks are manufactured and calibrated with extreme care. Finished on the latest precision lapping equipment, Rockwell test blocks have a surface height rating of less than five micro-inches (CLA) and both test and supporting surfaces are flat and parallel prior to being calibrated.
Rockwell testers used in the Wilson Standards Laboratory for test block calibration conform to exacting requirements for both minor and major loads as well as for the depth measuring system. Load and depth measurements are traceable to the National Institute of Standards and Technology (NIST). Zero tolerance BraleĀ® penetrators and master blocks checked to historical Rockwell standards are used in constant monitoring of the calibration process. Test blocks are available in various hardness ranges. When ordering, specify hardness range and scale approximately the same as the work you will be testing.
Calibration Sets
For the most exacting requirements (including SPC inherent variability studies), Rockwell calibration sets consisting of two or three test blocks and matched penetrator, all calibrated to a high degree of uniformity, are available. Calibration sets provide a higher standard to rely on when there is a question of the condition of a test block or penetrator that has been used. Calibration sets are available for all Rockwell scales.
|
|
|
Tags: rockwell hardness
Posted in Calipers & Inspection Guages
You can leave a response, or trackback from your own site.